影像科学与光化学 ›› 1995, Vol. 13 ›› Issue (1): 68-73.DOI: 10.7517/j.issn.1674-0475.1995.01.68

• 研究简报 • 上一篇    下一篇

单层结构ε-CuPc光导体的静电照相特性──ε-CuPc的浓度的影响

蒲嘉陵, 张伟民, 付一良   

  1. 北京印刷学院技术系信息记录材料实验室, 北京102600
  • 收稿日期:1993-10-04 修回日期:1994-08-22 出版日期:1995-02-20 发布日期:1995-02-20
  • 通讯作者: 蒲嘉陵
  • 基金资助:
    国家自然科学与基金

ELECTRO PHOTOGRAPHIC PROPERTIES OF A SINGLE-LAYERED CuPc PHOTORECEPTOR-THE EFFECTS OFε-CuPc CONCENTRATION

PU JIA-LING, ZHANG WEI-MING, FU YI-LIANG   

  1. Lab. of Information-recording Materials, Dept. Printing Tech., Beijing Institute of Printing, Beijing 102600, P.R. China
  • Received:1993-10-04 Revised:1994-08-22 Online:1995-02-20 Published:1995-02-20

摘要: 本研究将ε-酞菁铜(ε-CuPc)按不同浓度分散在一种聚酯树脂(Vylon200)中,并布在铝板基上构成光导体。测试结果表明,这种光导体可用作正充电或负充电光导体,但在相同的有效充电电位下,即,在V-V_T(其中V_T为临界充电电位)相同的条件下,负充电的表面饱和电压高于正充电的表面饱和电压。当ε-CuPc的质量分数超过40%时,光导体的暗衰减速度过快;当ε-CuPc的质量分数低于20%时,暗衰减速度虽然得到控制,但光衰减速度太低,而且残留电位大幅度增高。ε-CuPc的质量分数在30~40%被认为是适当的。

关键词: 有机光导体, ε-酞菁酮, 光导中心浓度

Abstract: Photoreceptor used in this study was a single-layered ε-CuPc which was prepared bydispersing the photoconducting pigment in a polyester at different concentrations and coatingthe dispersion on aluminum substrate. Results showed that such prepared devices can be usedas positive and negative-charging photoreceptors and the negative-charging yields higher surface potential than positive-charging under identical corona-discharging-voltage,i.e.,V-VT(VT is the threshold corona-discharging-voltage).High ε-CuPc concentrations over 40%induced too fast dark-decay.Dark-decay was brought under control by reducing the loadingof ε-CuPc to below 20%,but at the sacrifice of photo decay speed,resulting in higher residualpotential. The loading of ε-CuPc in the range of 30 to 40%was considered most proper.

Key words: organic photoconductor, ε-CuPc, concentration of photoconducting center